Use the following steps to install the Contour TV host DVR.
Important: If you are also installing a Contour TV client receiver, you must install the Contour TV host DVR first.
Self-Installing a Contour TV Host DVR
Share or Print This Article
Solution
1
Complete the following steps to plug in the Contour TV host DVR.
- Connect the coax cable to the Cable from Wall port on the Contour TV host DVR and to an active cable outlet.
- Connect the HDMI cord to the HDMI port on the Contour TV host DVR and to an HDMI input on your TV.
- Connect the power cord to the Contour TV host DVR and to an electrical outlet.
Note: Ensure that the electrical outlet isn't connected to a dimmer or a switched outlet.
2
Complete the following steps to activate the Contour TV host DVR.
- Power on your TV.
- Using your original TV remote, press the input or source button and select the HDMI input for the Contour TV host DVR.
- Follow the on-screen instructions.
- Wait a few minutes for the Contour TV host DVR to complete the activation.
3
Follow the on-screen instructions to set up your voice remote. When the setup is complete, and you see All Set on screen, press OK.
Cox Business MyAccount Updates
Cox Business MyAccount Updates
With the new and improved MyAccount portal from Cox Business, you’re in control. Included with your Cox Business services, it’s all right at your fingertips anytime, anywhere.
- Perform a health check on your services and reset your equipment
- Easily configure key features and settings like voicemail and call forwarding
- View your balance and schedule payments
Search Cox Business Support
Search Cox Business Support
Didn't Find What You Were Looking For? Search Here.
