Contour Voice Remote Control XR15

Contour 2 XR15 remote control, click for full-size image.

The Contour Voice Remote can be programmed for TVs and audio devices, and pairs with Contour 2 receivers to enable aim free control.

This remote offers some of the latest features:

Voice command – When the remote is paired to a receiver, you can search TV listings and On Demand, find a recorded show, change channels, set a recording, and more, with just your voice.
Control your devices.
- TV power, volume, muting, and input control.
- Audio device power, volume, and muting control.
Control your receiver without needing direct line of sight.
- Works when paired with your Contour 2 receiver.
- Pairs to the receiver through menu.
Power button - Turns on or off all devices programmed to your remote.
Automatic back light.
Remote LED.

The remote LED blinks when a command is sent to any device, and during setup and programming.
In paired RF mode, the remote blinks twice - once when a command is sent, and again when the receiver confirms receipt.

Note: The ability to replay live or recorded TV can be done using one of the following methods.

Pressing Pg Up or Pg Down will fast forward or rewind the program by 5 minutes.
Speaking into the voice remote can fast forward or rewind the program by the time spoken into the remote. As an example, "Rewind 15 seconds."

The color of the LED indicates whether the remote is operating in infrared (IR) or radio frequency (RF) mode, as shown in the table below.

LED Color	Status	Action
Green	A command was sent and received in RF mode.	No action required, the remote is paired to the receiver. If there is latency of more than 5 seconds, unpair and re-pair the remote and receiver.
Green, red	A command was sent in RF mode, but receiver did not confirm.	Unpair and re-pair the remote and receiver.
Red	A command was sent in IR mode. The LED blinks red once for all TV and audio device commands.	If the remote LED blinks red after a command to the receiver, such as pressing the GUIDE button, the remote is in IR mode. Unpair and re-pair the remote and receiver for RF operation.

What do you want to do next?

Cox Business MyAccount Updates

With the new and improved MyAccount portal from Cox Business, you’re in control. Included with your Cox Business services, it’s all right at your fingertips anytime, anywhere.

Perform a health check on your services and reset your equipment
Easily configure key features and settings like voicemail and call forwarding
View your balance and schedule payments

Learn more

Search Cox Business Support

Didn't Find What You Were Looking For? Search Here.